If you are not sure of the sequence, here is what I did:Ħ.Scroll to "Mouse - control view direction (on/off) Then, if I want to look around it is just a press of the trigger and the mouse changes mode. If I want at any time to stay in that particular position, say when doing an engine start, I just clich the trigger and it stays there allowing me to use the mouse to click awitches etc. I've been through all this since FS9 through to P3Dv3.4, and the only way you can get the mouse to do as it did in the early days is to get it assigned to a button on your joystick or throttle - then when you press this button (I use the Hotas Warthog trigger in P3D) the mouse can view all over the cockpit and the scroll wheel zooms in and out. But I still cannot use the mouse center wheel as the initiator, and not all aircraft with VC will allow me to look around. I then have to hit the button again to use the point and click. Here is what I have had to settle for so far, I had to set a button on the yoke to push to activate "mouse look toggle," which allows me to in some aircraft look around. It has mouselook, mouse look and other mouse commands.
So I did what we all do in FSX, I deleted all controls in p3d and just use FSUIPC. I tried at first to use P3D controls and buttons but found out rather quickly that was not going to work.
I have Saitek Pro everything to include an extra throttle quadrant. THis is what kind of end state I am shooting for. I want to be able to press the center button on my mouse and look around in VC, or press the mouse center and go back to normal pointer with no movement in the cockpit. But now we are in V2.1, I can have the mouse but I cant find the right configuration to what I want. I later got it back after figuring out that you have to make sure that Aero is working. When P3D v2.0 first came out I lost the ability to use my mouse in VC. OK, I know this may be a real minor issue, but to me it would keep me going grayer than necessary.
0 kommentar(er)
